Browsing Division of Mechanical Sciences by Subject "Magnesium Alloys"
Now showing items 1-10 of 10
-
Corrosion And Wear Behaviour of Plasma Electrolytic Oxidation And Laser Surface Alloy Coatings Produced on Mg Alloys
(2017-10-11)In the present investigation, surface coatings employing laser surface alloying (LSA) and plasma electrolytic oxidation (PEO) processes have been prepared on Mg alloys. The coatings have been investigated for corrosion and ... -
Creep, Wear And Corrosion Behaviour Of Novel Magnesium Alloys And Composites
(2011-04-01)In the present investigation, MMCs have been fabricated using the creep-resistant AE42 magnesium alloy as matrix and reinforcing it with saffil short fibres (essentially δ-Al2O2) and SiC particles in various combinations. ... -
Development Of Cast Magnesium Alloys With Improved Strength
(2014-05-15)Aim of the present work was to explore the possibility of improving strength of cast Mg by alloying additions, viz., Si and Zn+Al. All the alloys were produced by squeeze casting technique using squeeze pressure of 12MPa ... -
Effect of Li Addition on the Plasticity of AZ31 Mg-Alloy
(2017-11-14)Mg-alloys, despite being the lightest structural metallic materials, find limited applications due to their poor workability, which is due to the hcp structure that does not provide sufficient number of independent slip ... -
Evolution Of Texture And MIcrostructure During Processing Of Pure Magnesium And The Magnesium Alloy AM30
(2011-07-01)Magnesium is the lightest metal that can be used for structural applications. For the reasons of weight saving, there has been an increasing demand for magnesium from the automotive industry. However, poor formability at ... -
Experimental and Numerical Investigation of Mode I Fracture Behavior in Magnesium Single Crystals
(2018-04-02)Magnesium alloys, owing to their low density and high specific strength, are potential candidates for structural applications in automotive and aerospace industry. While considerable research effort has been devoted in ... -
Metastable Phases In Mg-Based Alloys
(Indian Institute of Science, 2005-12-22)Mg-based alloys form a variety of interesting structures including stable and metastable crystalline, stable and metastable quasicrystalline, nanocrystalline and amorphous phases. Many of these phases can be made to coexist ... -
Microstructure And Mechanical Properties Of Consolidated Magnesium Chips
(2013-04-04)Development of sustainable manufacturing and conservation of primary materials are the key challenges to environmental degradation and climate change. Recycling of primary materials is one of the approaches suggested for ... -
Microstructure And Texture Evolution And Its Effect On Mechanical Properties In Dilute Magnesium Based AZ21 Alloy
(2009-03-05)Dilute Mg alloys are exclusively identified for wrought structural applications in automotive industry. Any improvement in mechanical properties of alloys is possible only by grain size refinement and by the development ... -
Superplastic Deformation Behaviour Of AZ31 Magnesium Alloy
(2009-05-29)Superplastic deformation behaviour of AZ31 magnesium alloy having initial grain sizes 8, 11 and 17μm alloy was investigated at 673 K with initial strain rates ranging from 1x10-2 to 1x10-4 s-1. Mechanical data on fine ...