Search
Now showing items 71-78 of 78
Effect of Electric Current Pulses on Pre-cracked Thin Metallic Conductors: From Crack Propagation to Healing of Cracks
Both scientifically and technologically, it is important to investigate the effects of electric current on the structural integrity of metallic components. As an electric current reverses its direction across a crack, ...
Investigations of Sensors Based on New Molecular Architectonics: Synthesis, Fabrication and Application
Rapid industrialization and expansion of urban landscapes in large cities generate maximum
polluting ingredients to the surrounding environment. While organic contaminants are
naturally occurring, the increase in human ...
Microstructure-Corrosion Property Correlation in Electrodeposited Sn and Cu Based Coating Systems
Conventional metallic coatings are widely used for protection against corrosion. This study investigates the correlation between microstructure and corrosion properties in SnCr and CuCr electrodeposited coatings. The wide ...
Uniaxial Fatigue Behavior of Freestanding Platinum-Aluminide (PtAl) Bond Coat
Pt-aluminide (PtAl) bond coat is used as a part of Thermal Barrier Coating (TBC) system on Ni-base superalloy components in advanced gas turbine aeroengines. The thickness of B2-NiAl intermetallic based diffused coating ...
High-Throughput Bending Tests for Investigating Creep Behavior Affected by Structural and Microstructural Inhomogeneities
The bending of cantilevers is an alternate technique for the extraction of power-law creep parameters of materials. It has been shown earlier that in homogeneous systems showing tension-compression symmetry, digital image ...
Inkjet-printed high performance oxide electronics and its application at sensor interfaces
Over the last two decades, printing of oxide semiconductors has received special attention due to its advantages such as low processing temperature, even at room temperature; high electron mobility; good transparency due ...
Thermoplastic epoxy designed using Vitrimer chemistries
Globally, 70 million tons of epoxy thermosets are manufactured at a perplexing rate which constitutes approximately a quarter of polymer generation by weight. A thermosetting polymer contains a permanent crosslinked network ...
Effect of thermo-mechanical treatment on the evolution of microstructure and mechanical properties in a β and a β rich α+β titanium alloy
Near β and metastable β-titanium alloys are difficult to process due to narrow processing window. Lower processing temperature causes difficulty in recrystallization of these alloys especially in the two phase conditions, ...