Search
Now showing items 1-10 of 11
Studies On Acid Production Potential Of Some Sulphide Minerals And Bioremediation Of Acid Mine Drainage
(2009-08-19)
Acid mine drainage (AMD) is a worldwide environmental problem associated with the mining wastes, generated from active and inactive mining sites from mineral processing activities. AMD is defined as the drainage that occurs ...
Kinetics Of Pressureless Infiltration Of Al-Mg Alloys Into Al2O3 Preforms : A Non-Uniform Capillary Model
(2009-03-06)
Al-Mg alloys spontaneously infiltrate into porous ceramic preform in a nitrogenous
atmosphere above 750 °C with Mg either pre-alloyed or introduced at the interface to
initiate the process. The governing process variables ...
Superplastic Deformation Behaviour Of AZ31 Magnesium Alloy
(2009-05-29)
Superplastic deformation behaviour of AZ31 magnesium alloy having initial grain sizes 8, 11 and 17μm alloy was investigated at 673 K with initial strain rates ranging from 1x10-2 to 1x10-4 s-1. Mechanical data on fine ...
Ion-Nitriding Of Maraging Steel (MDN 250A Grade) For Light Combat Aircraft Applications
(2009-05-12)
Maraging steels have got high strength and good toughness. Maraging steel MDN 250A grade is used for slat tracks on the leading edge of the wing of Light Combat Aircraft (LCA). This application requires high strength and ...
Study Of Fracture Properties Of NiAl Bond Coats On Nickel Superalloy By Three Point Bending Of Microbeams
(2009-05-13)
The continuing quest for higher performance levels of modern gas turbine engines has been accompanied by the demand for higher engine operating temperatures. The use of Thermal Barrier Coatings (TBCs) enabled gas turbines ...
Modeling Of Liquid Flow In A Packed Bed Under Influence Of Gas Flow
(2009-03-05)
The aim of the current study is to model (non-wetting) liquid flow in a packed bed under the influence of gas flow. It has been observed experimentally that non-wetting liquid flows in a packed bed in form of small droplets ...
Development And Validation Of Two-Dimensional Mathematical Model Of Boron Carbide Manufacturing Process
(2009-03-06)
Boron carbide is produced in a heat resistance furnace using boric oxide and petroleum coke as the raw materials. In this process, a large current is passed through the graphite rod located at the center of the cylindrical ...
Microstructure And Texture Evolution And Its Effect On Mechanical Properties In Dilute Magnesium Based AZ21 Alloy
(2009-03-05)
Dilute Mg alloys are exclusively identified for wrought structural applications in automotive industry. Any improvement in mechanical properties of alloys is possible only by grain size refinement and by the development ...
Tensile And Low Cycle Fatigue Behavior Of A Ni-Base Superalloy
(2009-12-14)
Background and Objective: Nickel-base superalloys, strengthened by a high volume fraction of Ni3Al precipitates, have been the undisputed choice for turbine discs in gas turbines as they exhibit the best available combination ...
Evolution Of Multivariant Microstuctures With Anisotropic Misfit
(2009-06-17)
Many technologically important alloys such as Ni base superalloys and Ti-Al base alloys benefit from the precipitation of an ordered β phase from a disordered α matrix. When the crystallographic symmetry of the β phase is ...